Using an Electrostatic Charge for Roll-to-Roll Changeover

Chargemaster applies a temporary charge to the leading edge of the roll of film at rewind. The edge then adheres to the core without the use of tape or messy adhesives. Finished product quality is enhanced by elimination of creases in the roll of film caused by tape and glue on the core.

Click to enlarge.

Solutions

PerforMAX 3 Static Control System The NEW PerforMAX 3 is the most advanced static control system available for monitoring static neutralizing performance. PerforMAX3 provides outstanding extended range performance to eliminate static charges even when installed 2" to 10" from webs (depending on conditions), and up to 20" on winders. UL and C UL approved.

Chargemaster CM30 & CM60, Static Charging Systems The Chargemaster CM supplies the high voltage for charging bars and various charging applicators, which are used to temporarily bond materials. The Chargemaster CM provides a simple and economical solution for a wide range of production processes.

Pinner and Pinner Bar NR Arc Resistant Static Charging Bars Versatile arc resistant bars for any static charging need.

Tetra Static Charging Bar A rugged static charging bar for use in areas where personnel will not contact the bar.

Electrostatic Charging Monitor The Electrostatic Charging Monitor tracks, and displays, the performance efficiency status of the Chargemaster electrostatic charging equipment.

Using an Electrostatic Charge for Roll-to-Roll Changeover

PerforMAX 3 Static Control System

Chargemaster CM30 & CM60, Static Charging Systems

Pinner and Pinner Bar NR Arc Resistant Static Charging Bars

Tetra Static Charging Bar

Electrostatic Charging Monitor